Characterization of the sludge produced in textile laundries in Agreste region of Pernambuco for use in alternative construction materials
DOI:
https://doi.org/10.33448/rsd-v10i4.14078Keywords:
Textile sludge; Industrial waste; Alternative materials; Construction materials.Abstract
The textile sludge is a waste resulting of the physicochemical treatment procedure carried out in the effluent of textile laundries. This material is classified by the Brazilian standard as a non-hazardous waste considering that, despite its varied chemical composition, its components do not present great risks of human contamination. In view of the inadequate disposal of this waste, it was noticed the need to alternatives that allow the use of this material, since, currently, there is no recycling or use. The aim, therefore, was to verify that construction materials are an excellent matrix that receives this waste, providing a considerable reduction in its inadequate disposal and the possible environmental damage it generates. Specific mass analyzes, laser granulometry, thermogravimetry and differential thermal analysis, X-ray fluorescence, X-ray diffraction, scanning electron microscopy and infrared spectroscopy by Fourier transform were executed, using them to characterize the sludge. A value of 2.20 g/cm3 was obtained for its specific mass and an average diameter of 26.10 ± 0.65 μm, with 97.15% Regarding its composition, its main components are CaO, MgO and SiO2, the waste being a partially amorphous material of them having a diameter less than 80 μm, what characterized the textile sludge as a filler. Subjecting the sample to heating, it was evident that it has about 20% organic matter. The textile sludge presented positive evidence that reiterates your use in alternative building materials.
References
Agência Estadual de Meio Ambiente. (2018). Lavando Limpo.
American Association of State Highway and Transportation Officials. (1991). Handbook of hot-mix asphalt paving.
Anjos, D. C. dos. (2017). Estudo sobre a influência do lodo têxtil gerado por uma lavanderia industrial, aplicado em argamassa de cimento Portland composto de fíler. Universidade Federal de Santa Catarina.
Anwar, T. B., Behrose, B. & Ahmed, S. (2018). Utilization of textile sludge and public health risk assessment in Bangladesh. Sustainable Environment Research, 1-6.
Aquino, R. C. (2015). Adição de resíduo de lodo da indústria têxtil na produção de blocos cerâmicos de vedação. Revista Eletrônica de Materiais e Processos, 10, 29–35.
Associação Brasileira de Normas Técnicas. (2004). NBR 10004: Resíduos sólidos – Classificação.
Associação Brasileira de Normas Técnicas. (2017). NBR 16605: Cimento Portland e outros materiais em pó — Determinação da massa específica.
Aziz, H. A., Ghazali, M. F., Omran A. & Umar M. (2017). Solidification and stabilization of the incinerated wastewater sludge from textile industry. AIP Conference Proceedings.
Cometti, J. L. S.; Silva, F. L.; Santos, F. J. H. & Lima, V. A. (2016). Diagnóstico ambiental comparativo entre 2014 e 2015 das indústrias têxteis do município de Toritama-PE. Congresso Brasileiro de Gestão Ambiental.
Damineli, B. L. (2013). Conceitos para formulação de concretos com baixo consumo de ligantes: controle reológico, empacotamento e dispersão de partículas. Universidade de São Paulo.
Departamento Nacional de Infraestrutura de Transportes. (1997). DNIT-ME 367/97: Material de enchimento para misturas betuminosas.
Dias Júnior, M. L. (2013). Incorporação de lodo têxtil em blocos cerâmicos. Universidade Tecnológica Federal do Paraná.
Ferreira, M. das N. (2018). Incorporação de lodo de estação de tratamento de efluentes (ETE) de lavanderia industrial em cerâmica vermelha. Universidade Estadual do Norte Fluminense.
Gonçalves, F. M.; Torres, J. W. M.; Pascoal, A. L.; Ferreira, T. E. D.; Ferreira, E. E. & Alexandrino, J. S. (2019). Aproveitamento do rejeito de lavra de ardósia para a produção de carga mineral. Holos Environment, 19 (2), 235-242.
Goyal, S., Rafat S., Sujant J. & Devender S. (2019). Utilization of textile sludge in cement mortar and paste. Construction and Building Materials, 214, 169–177.
Herek, L. C. S., Hori, C. E., Reis, M. H. M., Mora, N. D., Tavares, C. L. G. & Bergamasco, R. (2012). Characterization of ceramic bricks incorporated with textile laundry sludge. Ceramics International, 38, 951–959.
Hossain, M. S., Das, S. C., Islam, J. M.M. & Mamun, M. A. A. (2018). Reuse of Textile Mill ETP Sludge in Environmental Friendly Bricks – Effect of Gamma Radiation. Radiation Physics and Chemistry, 151, 77-83.
Leloup, W. D. A. (2013). Efeitos da adição de lodo têxtil e cinzas de lenha gerados no APL de confecções pernambucano em argamassas de cimento Portland. Universidade Federal de Pernambuco.
Lima, J. (2018). Efeito da relação molar SiO2/Al2O3 e nas condições de cura nas propriedades de geopolímeros obtidos com silicato de cinza de casca de arroz. Universidade Federal de Pernambuco.
Moravia, W. G.; Oliveira, C. A. S.; Gumieri, A. G. & Vasconcelos, W. L. (2006). Caracterização microestrutural da argila expandida para aplicação como agregado em concreto estrutural leve. Cerâmica, 52, 193-199.
Motta, L. M. G., & Leite, L. F. M. (2000). Efeito do fíler nas características mecânicas das misturas asfálticas [Filler effects on aphalt mixtures]. Portuguese.] In Proc., 11 Congresso Panamericano, 127, 1007–1017.
Oliveira, A. G. de. (2014). Estudo das propriedades mecânicas do lodo têxtil para fins de utilização em pavimentos rodoviários. Universidade Federal de Campina Grande.
Oliveira, A. G.; Barros, A. D.; Lucena, L. C. F. L.; Lucena, A. E. F. L. & Patricio, J. D. (2020). Evaluation of calcined textile sludge as a stabilizing material for highway soil. Journal of Traffic and Transportation Engineering (English Edition), 7 (5), 688-699.
Pereira, A. G.; Vieira, C. S.; Oliveira, M. B.; Paiva, C. A. & Silva, R. L. (2021). Avaliação laboratorial de misturas asfálticas à quente produzidas com grafite cominuído. Research, Society and Development, 10 (2), e25110212030.
Silva, L. R.; Gama, K. N. C.; Salles, P. V. & Braga, F. C. S. (2019). Concreto com cinza de casca de arroz (CCA) e resíduos de construção e demolição (RCD). Research, Society and Development, 8 (4), e2684861.
Silva Filho, A. R. A.; Duarte, A. D.; Sinesio, E. P.; Silva, G. L. & Pessôa, S. G. S. (2021). Classification, characterization and diagnosis of Jeans Processing Laundries in the City of Caruaru-PE, in Agreste Pernambucano. Research, Society and Development, 10 (1), e57810112186.
Sonai, G. G.; Souza, S. M. A. G. U.; Oliveira, D. & Souza, A. A. U. (2015). The application of textile sludge adsorbents for the removal of Reactive Red 2 dye. Journal of Environmental Management, 168, 149-156.
Souto, T. J. (2017). Estudo do comportamento químico e ambiental de efluentes industriais e resíduos sólidos oriundos de lavanderias do Polo têxtil no Agreste pernambucano. Universidade Federal de Pernambuco.
Velumani, P., SenthilKumar, S. & Premalatha, P. V. (2016). An Innovative Approach to Evaluate the Performance of Sludge-Incorporated Fly Ash Bricks. Journal of Testing and Evaluation, 44, 2155–2163.
Zanoni, S. M. (2013). Reutilização de resíduos de indústria têxtil como matéria-prima em cerâmica vermelha. Universidade do Extremo Sul Catarinense.
Zhan B. J. & Poon C. S. (2015). Study on feasibility of reutilizing textile effluent sludge for producing concrete blocks. Journal of Cleaner Production, 101, 174-179.
Zhan B. J., Jiang-Shan L., Xuan D. X. & Poon C. S. (2019). Recycling hazardous textile effluent sludge in cement-based construction materials: Physicochemical interactions between sludge and cement. Journal of Hazardous Materials.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2021 Lyneker Souza de Moura; Carina Lessa Silva; Ana Carolina dos Santos Reis; Erika Pinto Marinho; Ana Cecília Vieira da Nóbrega; Arnaldo Manoel Pereira Carneiro
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:
1) Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
2) Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
3) Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.
