Evaluation of the adhesiveness of the asphalt binder modified with textile sludge by means of digital image processing
DOI:
https://doi.org/10.33448/rsd-v10i4.13975Keywords:
Adhesiveness; Textile sludge; Asphalt mixtures.Abstract
Adhesiveness is an important quality indicator for asphalt mixtures of rolling layers in pavements. Frequent consequences of poor adhesion of the binder to aggregate are slippage and disintegration, as well as reduced durability. Thus, it is necessary to evaluate and fully understand this phenomenon. In the present research, different approaches were used in order to analyze the adhesiveness when there is incorporation of textile sludge, a polluting industrial residue also coming from textile laundries located at the Confeste do APL of Agreste Pernambucano, to asphalt matrices. The sludge was added directly to the adherent material in contents of 2.0 and 3.0% in relation to the total mass of the mixture, and these samples were compared, by means of adhesiveness, to the reference, without sludge. The adhesiveness was analyzed qualitatively by conventional adhesion test described by Brazilian standard DNIT ME 078/1994. The aggregate area covered by ligand was calculated by means of digital image processing and the mixture surface interface was analyzed by microscopy petrographic. The results showed that the insertion of sludge in the mixture does not affect the adhesion of the mixture, since the three samples did not present pickling of the film and the area covered by binder was 100%. Petrographic microscopy showed that the mastic film (binder and textile sludge) penetrated even smaller void pores, this result demonstrates that the increase in viscosity did not harm the spreading on the aggregate surface and that asphalt matrices can be a good form of imprisonment of the studied waste.
References
Abeda. (2010). Aditivos orgânicos melhoradores de adesividade - Usos e benefícios. Informativo Técnico Nº 1-Junho 2010 - Comissão Técnica da Abeda. Associação Brasileira das Empresas Distribuidoras de Asfaltos.
Associação Brasileira de Normas Técnicas. (2004). NBR 15184: Materiais asfálticos - Determinação da Viscosidade Brookfield.
Aquino, R. C. (2015). Adição de resíduo de lodo da indústria têxtil na produção de blocos cerâmicos de vedação. Revista Eletrônica de Materiais e Processos, 10, 29–35.
Balasubramanian, J., Sabumon, P. C., Lazar, J. U., & Ilangovan, R. (2006). Reuse of textile effluent treatment plant sludge in building materials. Waste Management, 26, n. 1, 22–28.
Bernucci, L. B., Motta, L. M. G. da, Ceratti, J. A. P., & Soares, J. B. (2008). Pavimentação asfáltica: formação básica para engenheiros. Rio de Janeiro: Petrobras, Abeda.
Chadbourn, B. A., Crow, B.L., Newcomb, D., Skok, Jr., E.L., & Spindles, S. (2000). The effect of voids in mineral aggregate (VMA) on hot-mix asphalt pavements. Final Report No. 2000-13. Department of Transportation – Minnesota.
Cogo, M. da C. (2011). Estudo de Caracterização e Disposição dos Resíduos de uma Indústria Têxtil do Estado do Rio Grande do Sul. Universidade Federal do Rio Grande do Sul.
Daltin, D. (2011). Tensoativos: química, propriedades e aplicações. São Paulo: Blucher.
Departamento Nacional de Infraestrutura e Transportes. (1994). DNIT ME 78: Método de Ensaio. Misturas Betuminosas - Adesividade de Agregado Graúdo a Ligante Betuminosa.
Furlan, A. P. (2006). Considerações acerca da adesão e da susceptibilidade à umidade de misturas asfálticas densas à luz de algumas propriedades mecânicas. Universidade de São Paulo.
Herek, L. C. S., Hori, C. E., Reis, M. H. M., Mora, N. D., Tavares, C. L. G. & Bergamasco, R. (2012). Characterization of ceramic bricks incorporated with textile laundry sludge. Ceramics International, 38, 951–959.
Hicks, R. G. (1991). Moisture damage in asphalt concrete. National Cooperative Highway Research, Program Synthesis of Highway Practice Transportation Research Board.
Hirsch, F. (2007). Estudo do comportamento de misturas asfálticas preparadas com diferentes tipos. Universidade Regional do Noroeste do Estado do Rio Grande do Sul.
Hu, X., Fan, S., Li, X., & Fuentes, L. (2019). Exploring the feasibility of using reclaimed paper-based asphalt felt waste as a modifier in asphalt-binders. Construction and Building Materials.
Lucas Júnior, J. L. O., Jr., Babadopulos, L. F. A. L., & Soares, J. B. (2019). Aggregate–binder adhesiveness assessment and investigation of the influence of morphological and physico-chemical properties of mineral aggregates. Road Materials and Pavement Design.
doi: 10.1080/14680629.2019.1588773
Lucas Júnior, J. L. O., & Soares, J. B. (2018). Desenvolvimento de metodologia para avaliação da adesividade agregado-ligante com o uso de processamento digital de imagem. Transportes.
doi:10.14295/transportes.v27i1.1552
Majidzadeh, K., & Brovold, F. N. (1968). State of Art: Effect of water on bitumen-aggregate mixtures. Highway Research Board, Special Report No. 98, 77p.
Pereira, A. S., Shitsuka, D. M., Parreira, F. J. & Shitsuka, R. (2018). Metodologia da pesquisa científica. Universidade Federal de Santa Maria, NTE. 1. ed. 67-69.
Pereira, G. da S. (2012). Aditivos Orgânicos Melhoradores de Adesividade. Boletim Técnico SINICESP.
Rocha Filho, D., Soares, D. T., Tavares, A. P.; Silva, G. S. N., & Ilha, L. M. (2018). Confecção de lâminas delgadas para análise de rocha. Universidade Federal do Pampa.
Silva Filho, A. R. A., Duarte, A. D., Sinesio, E. P., Silva, G. L., & Pessôa, S. G. S. (2021). Classification, characterization and diagnosis of Jeans Processing Laundries in the City of Caruaru-PE, in Agreste Pernambucano. Research, Society and Development, 10(1), e57810112186.
Taylor, M. A., & Khosla, N. P. (1983). State of the art: Stripping on asphalt pavement. Transportation Research Record 911. Washington, D.C.
Zanoni, S. M. (2013). Reutilização de resíduos de indústria têxtil como matéria-prima em cerâmica vermelha. Universidade do Extremo Sul Catarinense.
Zhan, B.J. & Poon, C.S. (2015). Study on feasibility of reutilizing textile effluent sludge for producing concrete blocks. Journal of Cleaner Production, (101), 174-179.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2021 Lyneker Souza de Moura; Ana Carolina dos Santos Reis; Carina Lessa Silva; João Pedro Santana Bezerra ; Ana Cecília Vieira da Nóbrega; Arnaldo Manoel Pereira Carneiro
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:
1) Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
2) Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
3) Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.
